Peel & Stick Installation Guide
Peel & Stick Wallpaper — Installation Guide
Please take a moment to read through this guide before hanging. It is important that you understand the entire process before you start. If you are unsure of any steps, contact us at hello@wallpaperpixi.com — we're happy to help!
For optimal adhesion, ensure the surface is smooth, clean, and dry. Remove any dirt, dust, grease, mildew, or ink stains. If dealing with heavily textured or damaged walls, consider using a heavy-duty wallpaper liner. We advise having two people for installation — so team up and enjoy the process!
Pre-Installation Checklist
- Clean the wall thoroughly with a microfiber cloth
- Remove nails, screws, and fill in any cracks
- Switch off electricity and remove socket/switch covers
- Sand rough areas smooth
- Maintain room temperature at 68°F (20°C) during installation
- Let wallpaper acclimate in the room for 24 hours before applying
⚠️ Important: For optimal adhesion, wait 4 weeks after painting walls. Washable and glossy paints may not adhere well. If using washable paint, prime with a PVA-based primer and let dry before hanging. Any wall texture, including orange peel texture, may prevent proper adhesion.
Tools you will need
- Microfiber cloth
- Measuring tape
- Spirit level
- Pencil
- Exacto knife or paper knife
- Triangle ruler
- Plastic squeegee smoother with felt edge
Step 1 — Prepare your panels Unroll the wallpaper or mural and separate the panels. Arrange them in hanging order from left to right on the floor. For murals, use the numbers on the back of each panel (always positioned at the bottom) to ensure correct orientation. Repeating patterns can be installed in any order. Align the design to ensure the pattern matches before proceeding.
Step 2 — Line up the first panel Start from the left side of your wall. Use a tape measure and spirit level to mark where Panel 1 should be positioned. With a pencil, create a vertical plumb line from floor to ceiling, then mark a horizontal line 19" from the wall with 1"–2" overhang on the left side of Panel 1.
⚠️ Your wall may not be perfectly straight — do not use it as a reference. Take time to get this right!
Step 3 — Install the first panel With your partner's assistance, peel about a third of the backing paper from the first panel. Align the top right edge with the marked plumb line, leaving a 2" overhang at the top. Once straight, continue removing the backing paper slowly while using the felt-tipped squeegee to apply pressure gradually from the middle, moving downward and outward. Smooth gently and evenly to avoid creasing. Smoothing diagonally helps remove trapped air. If repositioning is needed, gently remove and restick the panel until straight.
Step 4 — Butt up the panels When hanging multiple panels, align edge to edge — do not overlap! Peel about a third of the backing paper and visually match the design down the length of the wall. Once aligned, firmly press the panels together to conceal the seams. Smooth out any air bubbles using the felt-tipped squeegee or a soft cloth. Remove remaining backing paper and smooth until fully installed.
Step 5 — Repeat until finished Repeat the previous steps for all panels. Use a triangle ruler and sharp blade to trim excess from the final drop and top/bottom of all panels. Firmly smooth with the felt-tipped squeegee to remove air pockets. Repeat this smoothing step one week after installation for optimal results. Allow to dry at room temperature with adequate ventilation.
Enjoy your new WallpaperPixi wallpaper! 🎉
Questions? We're here to help at hello@wallpaperpixi.com